To start off a DC analysis, you must first launch the Capture Student application. Then click File>New>Project from the menu.Click on Analog or Mixed. The next page will ask if you want to open an existing or a blank project, click blank project. To start on the circuit, all wires, resistors, current sources, and voltage sources will be found on Place on the menu bar. Once the circuit is finished go to PSpice>new simulation profile. Type Bias in the name field and click create. Select Bias Point under the Analysis type and click OK. Finally, run the simulation by selecting PSpice from the menu and selecting run.
This an example done for one of the Homework problems from assignment 7
No comments:
Post a Comment